APPLICATION

• 14 spare input and output terminal for co-ordinate with other auxilary equipment such as konveyor, electronic weight scale, etc…

PARTS REMOVAL

• Reduce the diffuculty and lower the cost to built End of Arm tooling. Able to reach unconventional paths such as curves, hooks, undercut, exceptional route.

STACK AND ARRAY

• In one cycle can handle up 9 stack areas with individual stacking format. Otherwise can place 100 points on a same working surface.

INSERT AND GRID

• In one cycle can pick 9 different insertion materials into the mold. It can be feed from a single point or grid pallet or multi-station.

INSPECTION

• Reject program: When detecting the reject signal from injection molding machine, it can set the quantities and place on a different area.
• Inspection program : By setting the quality counter for Q/C purpose. For example to inspect the parts every 100 molding cycle once.
• Weight program : Check the quality parts by electronic weight scale. It can separate the defects.
• Cycle counter : By setting the total molding cycle. It only counting the good parts,inspection and defects will not taken into total count.

HAND HELD PENDENT

• One key one function designs for clearly commanded. Pulse generator can manually move the robot to designate location, safe and easy for programming. Multi-language switches and conversational method guides the operator through out user-friendly operation. Each teachable program can write up to 500 steps,each step can write 10 motion sequences together. All speeds can be adjusted by the percentage rate.